I recently wrote a piece of code that locked up paradox and i hit Ctrl + Break a bunch of time to try to get it to stop. No Success - had to pull up task manager and End Program.
Since that time when I start my application the debugger comes up and wont close. Any ideas?
Full approved member.
Member subscribes to this thread with a verified email.
Verify the debugger is not set to open in run nor design modes. Select Tools | Settings | Developer Preferences. Make sure Open in design and Open in run are not checked.
-- Mike Prestwood Prestwood IT Solutions Office (9AM to 4PM PST): 916-726-5675 x205 | Fax: 916-726-5676
Full approved member.
Member subscribes to this thread with a verified email.